User`s guide

5
Option 1-1-2:
Performing a Walk Test
This option enables you to check that zones
are operating correctly. You can test only
those wards that you have access to.
Each zone tested is added (once) to the
event log, which you can review using User
option 2-9 (page 31).
User 1 Menu 1
Test Menu
1. Press [ to select this option.
Test Menu 2
Walk Test
2. Use | or ¬, or press 2 to select Walk
Walk Walk
Walk
Test
TestTest
Test, then press [.
Walk test wards:
Ward > 1*......
3. Use the numeric keys to select the wards
to test, then press [. Any ward numbers
shown will be tested. (A “*” indicates that
the ward will not be tested, and “.”
Indicates that you have no access to the
ward.
ESC To Stop Test
& View Zones
4. Walk through your wards and operate all
detection devices.
0003 Active
As you activate each zone, the internal
sounders will emit a chime tone and the
display will identify the activated zone.
5. When you have finished the test, press
].