User`s guide

2
-
16 Simulation Examples
Transient Anal
y
sis
This example shows how to run a transient analysis on the
clipper circuit. This requires adding a time-domain voltage
stimulus as shown in Figure 2-13.
Fi
g
ure 2-13
Diode Clipper Circuit with a Voltage Stimulus
To add a time-domain volta
g
e stimulus
1
In Schematics, from the Markers menu, select Clear All.
2
Select the ground symbol beneath the VIN source.
3
From the Edit menu, select Cut.
4
Scroll down or select Out from the View menu.
5
Place a VSTIM symbol as shown in Figure 2-13.
If you do not
have the
Stimulus
Editor:
1
Place a VSIN symbol instead
of VSTIM, then double click
it.
2
Set values for the VOFF,
VAMPL, and FREQ
attributes as defined in step
13. Click Save Attr after
typin
g
each attribute’s value
to accept the chan
g
es. When
finished, click OK.
not
included
in: