User`s guide

2
-
14 Simulation Examples
3
Place the first cursor on the V(In) waveform:
a
Click the portion of the V(In) trace in the proximity of
4 volts on the x-axis. The cursor crosshair appears, and
the current X and Y values for the first cursor appear in
the Probe Cursor window.
b
To fine-tune the cursor location to 4 volts on the x-axis,
drag the crosshairs until the x-axis value of the A1
cursor in the Probe Cursor window is approximately
4.0. You can also press r and l for tighter control.
4
Place the second cursor on the V(Mid) waveform:
a
Right-click the trace legend symbol (diamond) for
V(Mid) to associate the second cursor with the Mid
waveform. The crosshair pattern for the second cursor
outlines the V(Mid) trace symbol as shown in
Figure 2-11.
b
Right-click the portion on the V(Mid) trace that is in the
proximity of 4 volts on the x-axis. The X and Y values
for the second cursor appear in the Probe Cursor
window along with the difference (dif) between the two
cursors’ X and Y values.
c
To fine-tune the location of the second cursor to 4 volts
on the x-axis, drag the crosshairs until the x-axis value
of the A2 cursor in the Probe Cursor window is
approximately 4.0. You can also press V+r and
V+l for tighter control.
Your ability to
g
et as close to 4.0
as possible depends on screen
resolution and window size.
Fi
g
ure 2-11
Trace Le
g
end
with V(Mid) Symbol Outlined