User`s guide

Bias Point Analysis 2
-9
Usin
g
the Simulation Output File
The simulation output file acts as an audit trail of the simulation.
This file optionally echoes the contents of the circuit file as well
as the results of the bias point calculation. If there are any syntax
errors in the netlist declarations or simulation commands, or
anomalies while performing the calculation, PSpice A/D writes
error or warning messages to the output file.
To view the simulation output file
1
In Schematics, from the Analysis menu, select Examine
Output to display the output file in the MicroSim Text
Editor window.
Figure 2-5 shows the results of the bias point calculation as
written in the simulation output file (
clipper.out).
Fi
g
ure 2-5
Simulation Output File
2
When finished, close the MicroSim Text Editor window.
To view the results of the bias
point calculation directly on your
schematic, see
Using the Bias
Information Display on
page 2-7.