User`s guide

Example Circuit Creation 2
-3
4
Move the pointer to the correct position on the schematic
(see Figure 2-1) and click to place the first source.
5
Move the cursor and click again to place the second source.
6
Right-click to cancel placement mode.
To place the diodes
1
Go to the Part Browser dialog box.
2
In the Part name text box, type
D1N39* to display a list of
diodes.
3
Click D1N3940.
4
Click Place (to leave the dialog box open) or Place & Close
(to close the dialog box).
5
Press C+r to rotate the diode outline to the correct
orientation.
6
Click to place the first diode (D1), then click to place the
second diode (D2).
7
Right-click to cancel placement mode.
To move the text associated with the diodes (or
an
y
other ob
j
ect)
1
Click the text once to select it.
2
Drag the text to a new location.
To place the other components
Follow similar steps as described for the diodes to place the
components listed below. The symbol names you need to type
in the Part name text box of the Part Browser dialog box are
shown in parentheses:
• resistors (R)
• capacitor (C)
• ground symbols (EGND)
• bubble symbols (BUBBLE)
If needed, click to redisplay
the Part Browser dialo
g
box.
When placin
g
components:
• Leave space to connect the
components with wires.
• You will chan
g
e device
names and values that don’t
match those shown in
Fi
g
ure 2-1 later in this
section.
To refresh the schematic display,
select Redraw from the View
menu or press C+l.