User`s guide

Setpoints A
-5
Unlike the IC pseudocomponents, NODESET provides only an
initial guess for some net voltages. It does not clamp those nodes
to the specified voltages. However, by providing an initial
guess, NODESET symbols may be used to break the tie (in a
flip-flop, for instance) and make it come up in a desired state. To
guess at the bias point, enter the initial guess in the Value text
box for the VALUE attribute. PSpice A/D attaches a voltage
source with a 0.0002 ohm series resistance to each net to which
an IC symbol is connected.
These pseudocomponents are netlisted as PSpice A/D .IC and
.NODESET commands. Refer to these commands in the online
MicroSim PSpice A/D Reference Manual for more information.
Setpoints can be created for inductor currents and capacitor
voltages using the IC attribute described in Setting Initial
Conditions on page A-6.