User`s guide

Viewin
g
Bias Point Volta
g
es and Currents 18
-7
Chan
g
in
g
the Precision of
Displa
y
ed Data
By default, Schematics displays voltage and current values with
four significant digits. This means up to a total of four digits on
the left and right of the decimal point.
If you want to see more or fewer significant digits, you can
change the display setting. Schematics immediately updates the
existing display, and uses the new precision value for any
voltages and currents that you subsequently display on the same
schematic.
Note
An additional simulation is not required.
To chan
g
e the precision
1
From the Analysis menu, point to Display Results on
Schematic, and then select Display Options.
2
In the Significant Digits frame, select the number that you
want to view.
3
If you want to save this as the default for future sessions,
select (
✓) the Save As Default check box.
4
Click OK.
Movin
g
Volta
g
e and Current
Labels
To improve readability, you can relocate voltage and current
labels for the active editing session. If you later move sections
of the schematic, the labels maintain their relative position to the
wire (for voltage labels) or pin (for current labels).
To move a volta
g
e or current label to a new
location
1
Click the voltage or current label to select it. A box appears
around the label.
2
Drag it to the new location.
Note
If you flip or rotate a
portion of a schematic,
Schematics positions the
volta
g
e and current labels at
their default position near the
relevant wire se
g
ment or pin,
whether or not you had
previously repositioned the
label yourself.