User`s guide

18
-
6 Viewin
g
Results on the Schematic
Showin
g
Currents
By default, current display is initially disabled for all device pins
in your schematic. When you enable current display, the values
you see are the currents flowing into the pins.
Note
For di
g
ital parts, current information is not
available.
To enable/disable current displa
y
1
From the Analysis menu, point to Display Results on
Schematic, and then select Enable Current Display.
A
✓ means that current display is enabled; no check means
that current display is disabled and the dependent command,
Show/Hide Selected Currents, is dimmed on the submenu
and on the toolbar.
Clearin
g
and addin
g
selected current values
You can add and clear current values using procedures similar
to those for voltage values. Keep in mind these differences:
• Current values correspond to pins on part symbols.
• To show or hide current values, select a part symbol that has
pins you are interested in.
• Use the Show/Hide Selected Currents command to toggle
current display for the selected device’s pins.
Note
If your selection includes a mix of devices with
cleared and displayed current values, selectin
g
Show/Hide Selected Currents the first time will
clear the display for the selected devices’ pins. To
display them, select Show/Hide Selected Currents
a
g
ain.
On the Toolbar
this means enabled
this means disabled
select a device s
y
mbol...
...to to
gg
le
currents at pins