User`s guide

18
-
4 Viewin
g
Results on the Schematic
Showin
g
Volta
g
es
By default, voltage display is initially enabled for all nets in your
schematic. This means bias voltage values appear once for each
net on each schematic page or level of hierarchy, either under
the user-defined label for the net or next to the middle of the
longest wire segment.
Note
For di
g
ital parts, di
g
ital states are displayed
instead of volta
g
es.
To enable/disable volta
g
e displa
y
1
From the Analysis menu, point to Display Results on
Schematic, and then select Enable Voltage Display.
A
✓ means that voltage display is enabled; no check means
the voltage display is disabled and the dependent command,
Show/Hide Selected Voltages, is dimmed on the submenu
and on the toolbar.
Clearin
g
and addin
g
selected volta
g
e values
To clear selected volta
g
es from the existin
g
displa
y
1
Do one of the following to select one or more voltage
values:
• Select wire segments that have a voltage value next to
them.
• Select voltage value text (labels).
2
From the Analysis menu, point to Display Results on
Schematic, and then select Show/Hide Selected Voltages to
clear voltages for the selected wire segments.
Note
If your selection includes a mix of cleared and
displayed volta
g
e values, selectin
g
Show/Hide
Selected Volta
g
es the first time will clear the
display for the selected wire se
g
ments. To display
them, select Show/Hide Selected Volta
g
es a
g
ain.
You can also display the volta
g
e
more than once for a net by
usin
g
the Show/Hide Selected
Volta
g
es command on different
wire se
g
ments.
On the Toolbar
this means enabled
this means disabled
select a volta
g
e label
select a wire