User`s guide

Viewin
g
Bias Point Volta
g
es and Currents 18
-3
• A given voltage or current source can have a different DC
value and initial transient value at TIME=0. This means the
initial transient bias calculation can be different from the
DC (small-signal) bias point.
The Bias Information Toolbar
Buttons
The easiest way to control bias information display is to use the
buttons on the simulation toolbar. In the following diagram, the
description of each toolbar button corresponds to a command in
the Display Results on Schematic submenu that you can access
from the Analysis menu.
The Enable Displa
y
buttons
The Enable Voltage Display and Enable Current Display
buttons are push buttons that let you toggle the display
functions. When you enable display by clicking the buttons,
they appear pushed in as shown above.
The Show/Hide buttons
The Show/Hide Selected Voltages and Show/Hide Selected
Currents buttons let you toggle the voltage and current display
for selected wires and device pins. The buttons are unavailable
unless you enable the corresponding display and make
appropriate selections on your schematic.
Note
For a transient
analysis, only the initial
transient bias values are
available for display.
Displa
y
Results on Schematic submenu
Enable Volta
g
e
Show/Hide
Enable Current Displa
y
Show/Hide
Displa
y
Selected Volta
g
es
Selected Currents
The correspondin
g
submenu
commands are checked.
The correspondin
g
submenu
commands are dimmed.