User`s guide

Definin
g
a Di
g
ital Stimulus 14
-11
To delete a transition
1
Click the transition you want to delete.
2
If needed, press V+click to select additional transitions on
the same signal or different signals.
3
From the Edit menu, select Delete.
Definin
g
bus transitions
The steps to create a bus are:
1
Create the digital bus stimulus.
2
Introduce transitions.
3
Optionally define the radix for bus values.
These steps are described in detail in the following procedures.
To create a di
g
ital bus stimulus
1
From the Stimulus menu, select New.
1
In the Digital frame, choose Bus.
2
If needed, change the bus width from its default value of 8
bits: In the Width text box, type a different integer number.
3
Click OK.
During any interval, the bits on the bus lines represent a value
from zero through (2
n
- 1), where n is the number of bus lines.
To set bus values, introduce transitions using either of the two
methods described below.
press D