User`s guide

14
-
10 Di
g
ital Simulation
To add a transition
1
In the Stimulus Editor, from the Edit menu, select Add.
2
Click the digital stimulus you want to edit.
3
Drag the new transition to its proper location on the
waveform.
4
If you want to add more transitions, repeat steps 2
and 3.
5
When you are finished, right-click to exit the edit mode.
To move a transition
1
Click the transition you want to move.
2
If needed, use V+click to select additional transitions on
the same signal or different signals.
3
Reposition the transition (or transitions) by dragging.
Note
If you press V while dra
gg
in
g
, then all selected
transitions move by the
same amount
.
To edit a transition
1
Do one of the following:
• Click the transition you want to edit, and then, from the
Edit menu, select Attributes.
• Double-click the transition you want to edit.
2
When the Stimulus Attributes box appears, edit the timing
and value of the transition.
3
Click OK.
When you have selected a
transition to edit, a red handle
appears.