User`s guide

11
-
16 Transient Analysis
Fi
g
ure 11-3
Example Schematic example.sch
The transient analysis does its own calculation of a bias point to
start with, using the same technique as described for DC sweep.
This is necessary because the initial values of the sources can be
different from their DC values. If you want to report the small-
signal parameters for the transient bias point, you should use the
Transient command and enable Detailed Bias Point. Otherwise,
if all you want is the result of the transient run itself, you should
only enable the Transient command.
In the simulation output file
example.out, the bias-point report
for the transient bias point is labeled INITIAL TRANSIENT
SOLUTION.
The example circuit
example.sch is provided with
the MicroSim pro
g
ram
installation.