User`s guide

Bias Point Detail 9
-9
Bias Point Detail
Minimum Requirements to Run a
Bias Point Detail Anal
y
sis
Minimum circuit desi
g
n requirements
None.
Minimum pro
g
ram setup requirements
• In the Analysis Setup dialog box, select ( ✓) the Bias Point
Detail check box to enable it.
• Start the simulation as described in Starting Simulation on
page 8-11.
Overview of Bias Point Detail
The bias point is calculated for any analysis whether or not the
Bias Point Detail analysis is enabled in the Analysis Setup
dialog box. However, additional information is reported when
the Bias Point Detail analysis is enabled.
When Bias Point Detail analysis is not enabled, only analog
node voltages and digital node states are reported to the output
file.
See Setting Up Analyses on
page 8-3 for a description of the
Analysis Setup dialo
g
box.
Also see Save and Load Bias
Point on page A-2.