User`s guide

Startin
g
Simulation 8
-11
Startin
g
Simulation
Once you have used MicroSim Schematics to enter your circuit
design and to set up the analyses to be performed, you can start
simulation by selecting Simulate from the Analysis menu. When
you enter and set up your circuit this way, the files needed for
simulation are automatically created by Schematics and the
simulator is started from Schematics.
There may be situations, however, when you want to run
PSpice A/D outside of Schematics. You may want to simulate a
circuit that wasn’t created in Schematics, for example, or you
may want to run simulations of multiple circuits in batch mode.
This section includes the following:
Starting Simulation from Schematics
, below
Starting Simulation Outside of Schematics
on page 8-12
Setting Up Batch Simulations on page 8-12
The Simulation Status Window on page 8-14
Startin
g
Simulation from
Schematics
Once you have set up the analyses for the circuit, you can start
simulation from Schematics any of the following ways:
• select Simulate from the Analysis menu
• press !
• click on the Simulate icon