User`s guide

Settin
g
Up Analyses 8
-3
The Probe waveform analyzer is used to display and graphically
analyze the results of PSpice A/D simulations for swept
analyses. Supplementary analysis information is generated to
the simulation output file in the form of lists and tables.
Settin
g
Up Anal
y
ses
To set up one or more anal
y
ses
1
In the schematic editor, from the Analysis menu, select
Setup.
2
In the Analysis Setup dialog box, click an analysis button.
3
If a setup options dialog box is displayed for the selected
analysis type, complete the specification appropriately.
4
If needed, select (
✓) the check box next to the analysis-type
button to enable the analysis.
5
Set up any other analyses you want to perform for the
circuit.
Statistical analyses
Monte Carlo Monte Carlo/
worst-case
Sensitivity/worst-case Monte Carlo/
worst-case
Table 8-1
Classes of PSpice A/D Analyses (continued)
Analysis
Analysis Setup
Dialog Box
Swept
Variable
See Part Four, Viewing Results,
for information about usin
g
Probe.
Note
Monte Carlo and
sensitivity/worst-case
analyses are not
supported by
PSpice A/D Basics+.
Specific information for settin
g
up each type of analysis is
discussed in the followin
g
chapters.
See Output Variables on
page 8-5 for a description of the
output variables that can be
entered in the setup options
dialo
g
box displayed for an
analysis type.