User`s guide

Part Three
Settin
g
Up and Runnin
g
Anal
y
ses
Part Three describes how to set up and run analyses and provides
setup information specific to each analysis type.
Chapter 8,
Setting Up Analyses and Starting Simulation,
explains the procedures general to all analysis types to set up and
start the simulation.
Chapter 9,
DC Analyses, describes how to set up DC analyses,
including DC sweep, bias point detail, small-signal DC transfer,
and DC sensitivity.
Chapter 10,
AC Analyses, describes how to set up AC sweep
and noise analyses.
Chapter 11,
Transient Analysis, describes how to set up
transient analysis and optionally Fourier components. This
chapter also explains how to use the Stimulus Editor to create
time-based input.
Chapter 12,
Parametric and Temperature Analysis, describes
how to set up parametric and temperature analyses, and how to
run post-simulation performance analysis in Probe on the results
of these analyses.