User`s guide

Usin
g
the Parts Utility to Create Symbols 5
-11
Completin
g
the Confi
g
uration of
Your Part
The only thing left to do is to make sure PSpice A/D knows
where to find the model library that contains the model
definitions corresponding to the symbols you just created.
To confi
g
ure the model librar
y
1
Click in the schematic editor window.
1
From the Analysis menu, select Library and Include Files.
2
In the File Name text box, type the name of the library
including the file extension.
3
Click Add Library* (with an asterisk) to configure the
model library for global use.
4
Click OK.
Usin
g
the Parts Utilit
y
to
Create S
y
mbols
If you want to run the Parts utility and enable automatic creation
of symbols for any model that you create or change, then run the
Parts utility alone. This means any models you create are not
currently tied to a part instance on your schematic or to a symbol
editing session.
Note
If you open an existin
g
model library, the Parts
utility creates symbols for only the models that you
chan
g
e or add to it. If you want to create symbols
for all model definitions in a library, or for model
definitions that the Parts utility does not support,
then use the symbol wizard (see
Using the Symbol
Wizard on page 5-6 ).
not
included
in:
To find out how to use Parts to
create models, see
Using the
Parts Utility to Edit Models on
page 4-10.
To find out which device types
the Parts utility supports, see
Parts-Supported Device Types
on page 4-12.