User`s guide

Usin
g
the Parts Utility to Edit Models 4
-15
To fit the model
1
For each device characteristic that you want to set up:
a
In the Model Spec list, select the device characteristic.
b
From the Edit menu, select Spec.
c
In the Edit Model Spec dialog box, type in the device
information from the data sheet.
d
Click Add.
e
Click OK.
2
From the Extract menu, select Parameters to extract all
relevant model parameters for the current specification.
An asterisk (*) appears next to each extracted model
parameter.
3
Repeat steps 1
-2 until the model meets target behaviors.
To view performance curves
1
From the Model Spec list, select a device characteristic.
2
From the Plot menu, select Display.
Note
If you view performance curves before fittin
g
, then
your data points and the curve for the current
model specification may not match.
Or, instead of steps a and b,
double-click the device
characteristic in the Model Spec
list.