User's Manual

1312
Installing and Activating Devices
SECTION III
Control
Install
Associate
Uninstall
Dining Room
Media Room
Bathroom
Smart Dimmer
Location
Devices
1 Device 1
2 Receptacle
Devices
Device 1 is ON
1 Device 1
2 Receptacle
Devices
Dim level at 30%
ALL
ON
ALL
OFF
Activating Individual Devices
2. Highlight the location of the device you want
to activate. Press the OK button.
3. To turn a device on or off, highlight the
device. Press the OK button. This can also
be done by pressing the ALL ON button to
turn the device on and by pressing the ALL
OFF button to turn the device off.
1. Select the “Control” option from the devices
menu. Press the OK button.
4. For dimmer control, highlight the device then
use the ALL ON and ALL OFF buttons. A
window will display the dim level from 0%
to 100% .
To increase the brightness level, press and
hold the ALL ON button on the controller.
Release the ALL ON button when desired dim
level is reached.
To decrease the brightness level, press and
hold the ALL OFF button on the controller.
Release the ALL ON button when desired dim
level is reached.
Installing and Activating Devices
SECTION III
1. Select the “Device Status” option from the
devices menu. Press the OK button.
Checking Device Status
2. Select the location of the device(s) that you
are checking. Press the OK button.
Location
Devices
Livingroom Light On
Hall Light Off
Bedroom Light 80% 1
Kitchen Light On
Device Status
Remove
Replace
Child Protection
Device Status
3. Scroll through the menu, allowing a few
seconds for the system to fetch the device
state for each device.