Specifications

71
Specifi cations
Automatic Alignment
Tube and hose applications that in the past were only feasible using hand
tools can now be tightened using the Cleco family of tube nut wrenches. This
operation takes place at a speed that signifi cantly increases your productivity.
Torque repetition accuracy is assured by the proven Clecomatic clutch and
motor that does not fatigue. These models use a single lever for tightening
with the nutrunner and for returning the socket to the initial position. The fl exibil-
ity, combined with the proven capabilities, signifi cantly increases the produc-
tion rate on your assembly line.
Make sure the socket is in the open position.
If this is not the case, push the lever down half
way to return the socket to the open position.
Push the tool on the fastener and push the
lever down fully to tighten the fastener.
To release the tool again, move the tool away
from the fastener and press the lever half way
to return the socket to the open position.
Off
Socket return
Forward
Torque Control
A – Clecomatic clutch
Motor
24
Tool Type
T – Tube nut wrench
Tool Type
R – Reversing mechanism
for socket alignment
24 R T A 20 T2
Socket Size
EA –1/4" M5 –5 mm MK 17 mm
EC –3/8" M6 –6 mm ML –18 mm
ED –7/16" MA –7 mm MM –19 mm
EE –1/2" MB – 8 mm MN –20 mm
EF –9/16" MD –10 mm MO –21 mm
EH –11/16" ME –11 mm MP –22 mm
EJ –13/16" MF –12 mm MQ –23 mm
EK –7/8" MG –13 mm MR –24 mm
EL –15/16" MH –14 mm MS –25 mm
EM –1" MI – 15 mm MT –26 mm
EO –1 1/8" MJ –16 mm (5/8") MU –27 mm (1 1/16")
Max. Square Socket Size
MG, 1/2"T2 head type
MM, 3/4"T3 head type
MU, 1 1/16"T4 head type 00, ## (special), T3 head type
Max. Torque (Nm)
T2 - 20 Nm
T3 - 30 Nm
T4 - 40 Nm
Base tool
Model Number Example
KS2 ED 0 0
Socket (to be ordered separately)
Head Size
T2 - 20 Nm max.
T3 - 30 Nm max.
T4 - 40 Nm max.
Output Drive
0 Partial thru hex
1 Thru hex
Head Size
KS2 - T2
KS3 - T3
KS4 - T4
NOTE: When you order, state the base tool and order the socket separately. The socket will
be mounted on the tool prior to shipment.
Extension
0 None 4 1/2"
2 1/4"
6 3/4"
3 Double thru hex
4 Partial double thru hex