Operator`s manual

MODEL CS 208 v2
OUTPUT MODULE
MAY 2003
3
Monitor 2 & 3
1. DIR/TAPE: Selects direct or tape return signals (for
busses ABC & D).
2-7. A,B,C,D,A1,A2: Assigns busses to Monitor 2/3 outputs
(L) = left, (R) = right when using stereo
headphones.
8. M/ST/MS: M = mono, ST = stereo, MS = mid-side. Only
applicable if stereo headphones are used.
(See rear panel)
9. LEVEL: Gain Adjustment.
Aux 1,
Aux 2
10,11.: Aux 1 & 2 master level controls.
12. BNC: 12 volts available to power a ‘Littlite’®
(See meter panel).
13. RETURNS: Trim pots (multiturn) to adjust return (tape)
level to Monitors 1, 2 & 3 and the meters.
Meter Section
14. AUX/CD Meters 3, 4 = CD or Aux outputs
(3 = C or A1, 4 = D or A2).
15. PFL: Meters 1, 2 can indicate PFL selected on the
input channels (momentary switch).
16. TAPE/DIR: Tape/Direct. Meters indicate the return sig-
nals. (1 = A, 2 = B, 3 = C, 4 = D). CD/Aux
switch (14) overrides the tape return.
Monitor 1 Section
17. COMM: Communications return (talkback) to Monitor
1 only (See appl. note for 2 returns). The
multiturn trimmer below this switch adjusts
the level.
18. PL 1: Private line assign to Monitor 1 (down = on).
See master PL switch #28.
19. TAPE/DIR: Tape or Direct to Monitor 1