Operator`s manual

MODEL CS 208 v2
MAY 2003
GENERAL NOTES
34
Standard configuration
All audio connectors are pin #2 hot. Mic ‘T’ powering is: Pin #2+12vDc.
Alternate phase to be specified at time of purchase.
Levels are set as specifications.
Meter types should be specified at time of purchase.
Access to output trimmers
All trimmers on the output module are accessible by removing the right side panel only (no need to
remove the module).
Tools: 1/16” & 5/64” Allen wrenches.
Warning The monitor outputs of this mixer are capable of driving low-impedance headphones at a very high level.
Before headphones are in use, set all monitor levels to minimum. Prolonged listening at high volumes
might affect your hearing.