Operator`s manual

MODEL CS 208 v2

Left Section

1. CH: Channel Power (down = on) Do not switch during recording.

2. PH/DYN/T: Phantom power, no mic power, T (AB) power

(Phantom power is normally 48 v, see layout A to change to 12 v).

3. ø: Phase (audio only). ø = normal phase, REV = reverse phase

4. Mic/Line: Microphone or line level in.

5. Pad: Attenuator to reduce either mic or line input levels.

6. HP 1: High pass filter, pre-transformer.

7. HP 2: High pass filter, post transformer & preAmps.

8. EQ: Equalizer bypass. Affects HF, MF & LF filters, not HP filters.

9-12. A,B,C,D: Channel to mix bus assigns. L(left), R(right) indicate monitor & pan

pot assignment.

13. LIM+LED: The limiter is a symmetrical peak detecting type & is completely out

of circuit when switched off. Threshold: See (15). Attack & release

times are preset internally (see layout A to change). The LED

indicates limiter action.

14. PFL/AFL+LED: Pre fade listen or After fade listen (post fader). The switch is not

momentary, the LED serves as warning that PFL or AFL is

selected.

15. Thres. Limiter threshold. Clockwise = lower threshold.

16.O/L Near overload indicator.

INPUT MODULE

MAY 2003