User`s guide

19
AUXILIARY X TAMP
12:00 Sun 01 JAN
The control unit has auxiliary tamper zones
for monitoring auxiliary devices. The lid of a
device has been removed. You may not
be able to set your system until the fault is
cleared. Contact your alarm company.
BELL TAMPER
12:00 Sun 01 JAN
The lid of the external sounder has been
removed. You may not be able to set your
system until the fault is cleared. Contact
your alarm company.
TEST CCTS FAILED
12:00 Sun 01 JAN
One or more zones failed during a test
routine initiated by your alarm company.
You can still set and unset your system but
you should contact your alarm company.
WARDS ISOLATED
12:00 Sun 01 JAN
One or more wards have been isolated to
enable access to areas with 24-hour
protection. Press [ to identify the isolated
wards.
TAMPER 0001
Office Window
This message is displayed when a zone's
tamper circuit has been activated.
CALL ENGINEER TO
RESET SYSTEM
An engineer code or remote reset code
needs to be entered to reset the system.
Reset Required
See CALL ENGINEER TO RESET SYSTEM.
RING A.R.C. FOR
REM. RESET CODE
You need to contact an Alarms Receiving
Centre for a remote reset code (see page
16).