User`s guide

10
Option 1-5: Enabling Chimes
This option enables you to select which of
your wards (if any) use the chime feature. In
a ward with this feature enabled, zones that
have a Chime Tone attribute (User option 2-
5) and are in a selected ward will generate a
chime tone when activated. The wards then
remain chime-enabled until you deselect
them with this option.
A zone may generate one or more chime
tones, depending on the Chime Tone
attribute selected in User option 2-5:
Chime tone 1 single chime
Chime tone 2 double chime
Chime tone 3 triple chime
The chime occurs only at keypads and
extension loudspeakers assigned to the
same ward(s) as the zone.
When a chime occurs, keypads display the
zone number if configured by the Chime
Visible setting in Engineer option 1-9-1-08.
User 1 Menu 5
Enable Chime
1. Press [ to select this option.
Chime on wards:
Ward > 1*......
2. Use the numeric keys to select the wards
you want to have chime enabled, then
press [. Any ward numbers shown will
be chime enabled. (A “*” indicates that
the ward will not be chime enabled. A “.”
Indicates that either you have no access
to the ward, or the ward is not
programmed.)