Installation guide

i-on16 4. Administration
Page 61
Remotes
1. Make sure the display shows
the standby screen.


2. Press .


3. Key in your access code (or
present a tag).


4. Press  until you see:.


5. Press .
The display shows:


6. Press  until you see:


7. Press .
The display asks you to press
any button on the remote you
wish to test.


If there are no remotes
available the display briefly
shows:


8. Press a button on the device
you wish to test (you should
press and hold the button
down until the transmit LED on
the device flashes).
The keypad gives a double
“beep” confirmation tone.
The top line of the display
shows: the number of the
device, the button you
pressed, and the user the
device is allocated to.
The bottom line of the display
shows the function of the

