Installation guide

Administration
Page 28
Outputs
You can operate radio output modules from the keypad,
as well as by using a telecommand. To operate an
output:
1. Enter the User Menu and select Outputs.
The display shows a list of outputs.
2. Use the u or n keys to select the output you want
to operate and then press CHANGE.
The selected output shows the word ON or OFF at
the end of its line
3. Press DONE.
The display returns to the list of outputs, and the
control unit sends a signal to the radio output
module to operate the appropriate output.
Telephone Call
If your 7510r is connected to a telecommunications line,
then you can start and end a telephone call from the
keypad. However, depending on the type of line
connected to your 7510r, you may not have complete
two way speech. If you are connected to:
PSTN You can dial out and listen to the remote end,
and also send DTMF tones from the 7510r
keypad. You can use this service for choosing
options from an automated answering service,
or to control equipment at the far end of the
line.
ISDN You can dial out and have a complete two way
speech with a person at the far end. You can
also send DTMF tones from the keypad.
GSM You can dial out and listen to the remote end,
and also send DTMF tones from the 7510r
keypad. This type of line should work with an
automated answering service, such as those