User guide

4. Programming
496929 Page 45
126: Select Language
The control unit can display messages on the keypads in one of several
different languages. Use Command 126 to select the language you wish to
use. The options available are:
0: English (default) 5: Francai (French)
1: Italian 6: Deutsch (German)
2: Espanol (Spanish) 7: Norsk (Norwegian)
3: Portugu (Portuguese) 8: Svenska (Swedish)
4: Nederl (Dutch) 9: Dansk (Danish)
151 - 158: Plug by Communicator Outputs
The main circuit board of the control unit provides eight programmable
outputs that can be used to control a plug-by communicator. The outputs can
be connected to the communicator by an twelve-way wiring harness provided
with the control unit. See “3. Installation - Fitting a Plug-by Communicator” for
details of the wiring harness.
Commands 151 to 158 allow you to assign one of several options to each
output. Command 151 controls output 1, 152 output 2, and so on up to
Command 158 which controls output 8. Each Command has the same
options, as follows:
00 Not used 16 Medical Assistance
01 Fire 17 Key Box
02 PA 18 Anti Mask
03 Burglar 19 Smoke Detector
04 Open/Close 30 Set o/p 1
05 Alarm Abort 31 Set o/p 2
06 Technical Alarm 32 Set o/p 3
11 AC Fail 33 Set o/p 4
12 Tamper Alarm (Day tamper) 34 Unset o/p 1
13 Open 35 Unset o/p 2
14 Close 36 Unset o/p 3
15 Zone Omitted 37 Unset o/p 4
159: Invert Plug by Outputs
This option allows the plug by outputs to operate as +ve applied. (By default
the outputs operate as +ve removed.)
Option
0 +ve Removed to trigger. The inactive output is +ve. When active the
output goes to 0V.