User guide

4. Programming
Page 24 496929
157 Plug by Comms Output 7
157YnnY
Not used. See Command 151
158 Plug by Comms Output 8
158YnnY
Default 06 Technical. See Command
151
159 Invert Plug-by Comms Outputs
0= +ve removed
1 - +ve Applied
Y
170 Set o/p 1 Time
Set o/p 2 Time
Set o/p 3 Time
Set o/p 4 Time
Set range
01-12
seconds
171 Set o/p 1 ABCD
Set o/p 2 ABCD
Set o/p 3 ABCD
Set o/p 4 ABCD
Toggle
ABCD
172 Unset o/p 1 Time
Unset o/p 2 Time
Unset o/p 3 Time
Unset o/p 4 Time
Set range
01-12
seconds
173 Unset o/p 1 ABCD
Unset o/p 2 ABCD
Unset o/p 3 ABCD
Unset o/p 4 ABCD
Toggle
ABCD
174 Fire o/p 1
Fire o/p 2
Fire o/p 3
Fire o/p 4
Select if o/p
required to
operate if a
Fire Alarm
175 PA o/p 1
PA o/p 2
PA o/p 3
PA o/p 4
Select if o/p
required to
operate if a
PA Alarm
Leaving Programming Mode
When all programming has been completed:
1. Key-in ‘99 Y’ at the keypad
The display shows:
99:Exit Eng ?
2. Press Y.
The display shows:
99:Checking Sys
followed by the time and date.
The system is now in user mode.
Note: If there is a fault, for example an open tamper circuit, the display shows
this and will not return to Day mode. Press X and rectify the faults.
Engineer Reset
To perform an Engineer Reset:
1. Check that the display is showing the alarm condition.
2. Key in 0 followed by the Engineer’s code (default 7890), followed by 99
YY.
The display shows the time and date.