User guide

3. Installation
Page 18 496929
Fitting a Battery
Fit a rechargeable battery into the back of the case. The case provides space
for a 12V 7AH battery. Make sure the battery terminals are oriented in the
position shown in Figure 16.
7AH
Figure 16. Fitting a Battery
Initial Start Up
Before applying power to the control unit, ensure that:
• All remote keypads have been addressed and connected.
• All external and internal sounders are connected.
• All wired zone circuits are connected.
Then:
1. Connect the battery to the control unit PCB.
2. Briefly short the kick start pins together (they are located above battery
connector, see Figure 3).
The green power LED on the keypad flashes and the internal sounder
may sound. Ignore any display at this stage.
3. Key-in the factory default user access code: 1234.
The internal sounder stops. Ignore any display at this stage.
4. Please fit the case lid before applying mains power (this also defeats the
tamper switch).
5. Apply mains power.