User guide

3. Installation

Page 10 496929

1. Fixing hole.

2. Adjustable cam.

Figure 4. Backplate of the 9930 Keypad

Cooper Security recommend that you mount the keypad using No 8 or 6

screws (M4/M3.5) as follows:

1. Select which cable entry you are going to use and break out the

appropriate plastic sections.

2. Hold the backplate in place against the wall and mark the position of the

centre hole in the adjustable cam (see Figure 4).

3. Drill and plug the hole, and screw the backplate to the wall through the

adjustable cam. Do not tighten the screw completely home.

4. Make sure the backplate is level and mark, drill and plug at least two

other fixing holes. Screw the backplate to the wall through the fixing

holes.

5. Cut the plastic webs connecting the cam to the remainder of the base

plate.

Note: If you do not cut the webs then the tamper switch will not operate if the

complete keypad is forced off the wall.

6. Mount the front of the keypad (containing the keypad pcb) onto the

backplate and make sure that the tamper switch operates.

8. If the tamper switch does not operate then rotate the cam until the

tamper switch operates correctly when the front of the keypad is

mounted on the backplate.

9. If the “Prox” reader and tags are required, follow the installation

instructions in the separate guide supplied with the 934EUR-00 Prox

reader.