User guide

497100, Issue 4 Page 9
2. Everyday Operation
During installation, your installer programs the system to create an exit route
and entry route for your premises. When setting the system, you must follow
the exit route. When unsetting the system, you must follow the entry route. If
you stray from these routes, you may cause a false alarm.
Setting the System
There are several different methods for setting the system. Each level or
partition can use a different method, although not all methods are available in
all cases. Your installer will have selected the methods that suit your site
best
3
.
The possible setting methods are:
Timed Set Instant Set
Final Door Set Keyswitch Set
Lock Set Telecommand Set
Terminated Set Forbikobler Keypad Set
Silent Set
The setting procedure is similar for each method and shown on page 10.
Subsequent sections describe the specifics of each setting method.
If you try to set the system while something is triggering a detector in the
protected area (for example a door or window is still open), the system will not
set (see page 13).
If you find that your detectors generate false alarms immediately after you
leave the premises, this may be because they are detecting air movements
when the exit door is closed. You may need to ask your installer to increase
the Final Exit Settling Time
4
.
3
Installer Commands 39, 62, 72 and 76
4
Installer Command 182