User guide

1. Introduction
497100, Issue 4 Page 7
723r Telecommand/ 722r PA
If your alarm system has a radio expander connected to it, you can use a 723r
telecommand (sometimes called a remote setting device) or the 722r PA
(Figure 3).
Figure 3. 723r Telecommand
Mains Power Failures
The control unit indicates mains power failures using alerts. If the supply has
since been restored, the alert will show the condition as inactive. For
instructions on how to view and acknowledge alerts, refer to page 21.
Transmit lamp
Glows when sending a signal
to the alarm system.
Level A button
Sets Level A (full system) in a
single system; sets Partition A in
a partitioned system.
Level B button
Sets Level B in a single system;
has no effect in a partitioned
system.
Unset button
Unsets Level A (full system) in a
single system; unsets Partition
A
in a partitioned system.
+
(722r only) Pressing Level
A
and Unset buttons at the
same time starts a panic
alarm (if enabled, see page
32). In a partitioned
system, the alarm is in
Partition A.
button
Not used.