User guide

4. Special Functions

Page 28 497100, Issue 4

Changing User Names

The system can store up to 12 characters for each user name, including

spaces and punctuation marks. The default names are in the form User nn.

You can change the name when you set the access code. In step 3 of the

procedure on page 26, the display shows the current user name with a

flashing cursor under the first letter. Enter letters one at a time in the same

way as when texting on a mobile phone, by repeatedly pressing a key until the

required letter is displayed. To move right, press C. To move left, press D.

1 None 7 P Q R S

2 A B C Æ Å Ä 8 T U V

3 D E F 9 W X Y Z

4 G H I 0 Space ' ( ) : . - ! &

5 J K L C Move right

6 M N O Ø Ö D Move left

To delete a whole name, move to the first character and press D.

When you have entered the name, press y to continue with setting the code.

Assigning a Duress Code

If your system is connected to an ARC, you may want to give a duress code

to some users as well as their access code. The duress code is designed to

send a silent communication if a user is forced to unset the system by an

intruder. It has to be enabled by your installer

. When unset with a duress

code instead of an access code, the system appears to respond normally but

the control unit sends a silent communication to the ARC. A user who has the

duress code can use any of the system's facilities.

The duress code is assigned to U51 and, when the control unit leaves the

factory, is inactive and set to "X051" (“X00051” for six digit codes). To activate

it, assign a new code to U51 using method 2 for assigning codes to other

users (see previous page).

Installer Command 49