User guide

4. Special Functions
Page 26 497100, Issue 4
When the system is delivered from the factory, all access codes are set to
default values. Depending how your installer has set up the system
18
, access
codes may contain four or six digits. The default for the master user (U01) is
"1234" when four-digit codes are in use and "123456" when six-digit codes
are in use; this user is assigned to all levels or partitions. The master user
should change this immediately to a code known to no one else.
The other defaults are "X002" for U02 through to "X050" for U50 (for six-digit
codes: “X00002” to “X00050”). As default codes cannot be used to set or
unset the system, or use any of its special functions, they do not need to be
changed until they are assigned to users.
Access Codes
There are two methods for changing the access code for a user.
Method 1:
1. Key in the master user access code.
2. Press 4.
The display shows:
Old Code=
----
3. Key in the master user access code again
and press y.
The display shows the “U01” and any text
description for that user:
U01:User 01
If you wish to change the name, use the keypad as
described in Changing User Names on page 28.
If you wish to change the master use access code
press Y and go to step 6.
4.
Press X repeatedly until the display shows the user
number of the code you want to add/change.
U23:User 23
If you wish to change the name, use the keypad as
described in Changing User Names on page 28.
5.
Press y.
The display shows (for example):
User 23:
----
6. Key in the new access code. The display shows (for
example):
User 23 = 4926
18
Installer Command 56