User guide

4. Special Functions
Page 22 497100, Issue 4
Omitting Zones
Your system may be programmed so that you can omit individual detectors.
This enables you to ignore alarms coming from faulty detectors in non-critical
positions. Refer to the table on page 32 to see which zones can be omitted in
your system.
Omission is not permanent: when you next unset the system, the control unit
reinstates any omitted zones. You must omit the zones each time you prepare
to set the system.
To omit a zone:
1. Key in an access code (or present a tag).
2. Press 2.
This display shows:
Omit Zone?
3. Press the number of the zone you want to
omit (for example, press 07 to omit zone
7) and then press y.
The sounder gives a double "beep" and
the display shows the zone number
followed by an "o":
Omit Zone 07o
If you try to omit a zone for which this is
not allowed, the display shows an "X"
after the zone number.
Omit Zone 07X
4.
Press X to exit.
Note: To include a zone that was omitted, follow the same procedure.
Pressing
y toggles between omit and include.
When you set the system after omitting some types of zones, a message asks
you to confirm that you want to omit the zone. Press y to set the system with
the zone omitted.
The zone types for which a message is displayed are: Normal Alarm (NA), 24-
hour (24), Final Exit (FE), Entry Route (ER), Shock Analyser (SA), Keybox
(KB), Keyswitch (KF or KM), Anti-Mask (AM) and Forbikobler (FB).
The zone types for which a message is not displayed are: Panic Alarm (PA),
Fire (FR), Technical (TC), Smoke Detector (SD), AC Fail (AC), Low Battery
(LB), Battery Fault (BF), Power Output Fail (PF) and Fault (FL).