User guide

2. Everyday Operation
497100, Issue 4 Page 13
Investigating Setting Problems
This section offers general guidance but the configurable nature of 9x5x
control units means that details of each alert and response vary. If you need
assistance to resolve a problem, contact your installer.
Detector Active
If something is triggering a detector at the end of the exit procedure, the
system will not set. Depending how your installer has set up the system
9
,
internal or external sounders may operate. The display shows which zone (or
zones) is active.
To set the system:
1. Enter your access code (or present your tag) to
silence any sounders.
2. Go to the zone shown on the display (see
example) and find out what is triggering the
detector. If possible, remedy the fault.
Zone Open Z03
Zone 03
3. Return to the keypad and set the system again.
If no other detectors are active, the system sets.
4. If other detectors are active, repeat steps 1 to 3.
5. If the system still will not set, call your installer.
Keypad Display Shows “Bypass Supr. Z?”
If you see the message at the right on your keypad
display when you are trying to set the system, then
one or more of your radio based detectors has a
problem. Press Y.
Bypass Supr. Z?
Active Set?
If the display reverts to the time and date then your system has been
programmed not to set in the event of a detector fault. You must call your
installer and they must attend to the system before you can carry on and use
it.
If you system carries on and sets, then your system has been programmed to
ignore problems with the radio detector in question. Carry on using your
system as normal, but report the problem to your installer.
9
Installer Command 27