User guide

2. Everyday Operation
Page 10 497100, Issue 4
General Procedure
To set the system:
1. Secure all doors and windows.
2. At the keypad, key in an access code
(or present a tag).
Note:If you enter an incorrect code, try again. If you enter an incorrect code four
times, all keypads will be locked for 90 seconds.
3.
In a single system:
The display shows (for example):
System OK
Set?
Press the appropriate level key.
Note: If you press y without a level key, the system sets Level A (Full Set).
In a partitioned system:
The display shows (for example):
System OK
Set? ABCD
Press A, B, C or D to remove a partition
from the display and leave it unset. Press y
when the display shows just those partitions
you want to set.
4. If you have omitted a zone (see page 22),
the display shows (for example):
Omit Zone 03?
Set? ABCD
Press y to continue with the zone omitted.
If you do not want to omit it, press X to exit.
During the exit procedure, the keypads give
a continuous exit tone. The tone may be
intermittent if the final door is open.
Setting ABCD 009
If you hear an intermittent tone from the
keypads or internal sounder and the final
door is not open, a detector is being
triggered (see page 12).
5. Leave by the designated exit route.
When you complete the exit procedure in
accordance with the setting method in use,
the system sets and gives a double "beep".
The keypad display shows which level or
partition is set.
Set ABCD
9x5x
Set A
9x5x
Note: If you decide not to set the system, key in your access code again (or
present a tag) to unset it.