Cut Sheet

Optional features
Coppertop compression connectors
Coppertop compression connectors (aluminum sleeve welded to
a copper spade) provide a high conductivity material in a bolted
connection and are compatible with aluminum or copper conductors.
All copper current path
Full copper current carrying path and 900 A rating can be obtained
by specifying a coppertop compression connector, copper stud and
copper insulating plug.
Shear bolt connector (optional)
Bolted cable lug is fitted with stepless bolts, which shear off when
optimum contact force has been reached. Provides electrical
continuity for copper and aluminum conductors while eliminating
need for dies and compression tools.
Figure 1. BOL-T Cutaway illustrates design features.
ote:N Dimensions given are for reference only.
SEMI-CONDUCTING SHIELD
Precision molded peroxide-cured
semi-conducting shield provides
ground shield continuity and meets the
requirements of IEEE Std 592
™
-2007
standard.
COMPRESSION CONNECTOR
(Compression Connector
pictured)
Aluminum compression
connector is sized to ensure a
cool running connector with
maximum current transfer.
Shear bolt connector
description below.
12.5 "
(318 mm)
9.6"
(244 mm)
EPDM INSULATION
High quality peroxide-cured
EPDM Insulation is mixed
and formulated in-house for
complete control of raw
rubber characteristics.
CABLE ADAPTER
Molded cable adapter, sized to fit cable
insulation diameters from 0.640 inch to
1.965 inches (16.3 to 49.9 mm), provides
stress relief for the terminated cable.
CAPACITIVE TEST POINT
Optional capacitive test point on
molded T-body with snap-on cap
provides a shielded, hotstick operable
means to determine circuit condition
when used with high impedance voltage
sensing devices designed for capacitive
test points, and a place to mount Eaton's
Cooper Power series TPR faulted circuit
indicators.
DRAIN WIRE TAB
Drain wire tab provides
aconvenient point to
connect a drain wire to
ensure grounding of the
connector shield.
SEMI-CONDUCTING INSERT
Molded semi-conducting peroxide-cured
insert provides corona-free electrostatic
shielding of the compression connector.
INSULATING PLUG
Molded epoxy insulating plug provides
excellent electrical, thermal and mechanical
reliability.
INSULATING PLUG CAP
Semi-conducting rubber cap fits over
insulating plug test point for water-
proof seal and deadfront shielding.
HEX HEAD
One-inch hex head
is used to tighten the
connection.
T-BODY
Molded T-body adapts
to all cable sizes and
provides a deadfront shield-
ed connection.
Figure 2. Shear bolt connector.
Figure 3. BOL-T stacking dimensions.
15/25 kV
S2 0.5" (13 mm)
S3 3.9" (98 mm)
S4 1.5" (38 mm)
S5 2.4" (61 mm)
S5
S2
S3
S4
3
Catalog Data CA650003EN
Effective February 2015
600 A 15/25 kV class BOL-T deadbreak connector
www.cooperpower.com