Operator`s manual

49
To Acknowledge a Call and Select Remote Access Mode:
When the telephone rings, answer the call as normal.
Listen to the voice message. The message is repeated 3 times in total.
When you have understood the message, you can select the Remote
Access Menu at any time by pressing the * key on your telephone (please
note that pressing 8 key will accept the call without entering the Remote
Access mode. You will hear a series of high-pitched beeps; at this point
enter the ‘Remote Access Code’ on your telephone; you will hear an
acceptance tone. The Remote Access Menu is now selected.
The Remote Access Menu
The following commands can be selected from the Remote Access Menu:
Function Key Sequence
Toggle Remote Control Output 1
[*] 1
Toggle Remote Control Output 2
[*] 2
Listen-in/Talkback Mode
[*] 3 To select 3 to toggle
Play Voice Messages 1 - 8
4 Followed by 1 - 8
Record Voice Messages 1 - 8
[*] 4 Followed by 1 - 8
Playback Memo
0
Record Memo
[*] 0
Stop Recording/Playback
0 or any key
Quit Remote Access Menu and hang-up
[#]
If after 30 seconds no command has been selected then SD2 will hang-up
the call. Once a command has been selected, the unit remains online for 3
minutes or until the Quit Remote Access command is used (#).
Toggle Remote Control Outputs
This Remote Access command allows you to either switch on or off the
remote control outputs.
To toggle the remote control outputs first establish a Remote Access
connection with the Speech Dialler.
Press * 1 on your telephone to toggle Remote Control Output 1 or * 2 to
toggle Remote Control Output 2. You will hear one high pitched beep when
Output 1 is switched on and two for Output 2. You will hear one low
pitched beep when Output 1 is switched off and two for Output 2.
Use your telephone to select other Remote Access commands or press # to
hang-up the connection with the SD2.