Operator`s manual

19
Messages
Recording Messages
The SD2 has eight voice messages, and one common site message; each
message can be up to 30 seconds long (in long play mode). The unit has
an internal microphone and loudspeaker, which are used to record and
playback the voice messages. Messages should be recorded to reflect the
type of alarm that is being triggered, e.g., if “trigger input 1” is connected
to a smoke alarm then “message 1” should state that there is a fire alarm
at the premises.
NB It is recommended that you record “Press 8 on your telephone to
accept this call” at the end of your message.
To Record and Playback A Voice Message:
From the main menu press ¬and ¦ or 2 to select the record message
menu:
1. Press [ to select:
2. Press [ to edit voice messages:
3. Press ¬ and ¦ or 1 – 8 to select the required voice message i.e. C
There are a total of 9 messages: Four “voice alarm” and four “voice
restores” plus a site message. For restore messages you must enable
trigger restore option in ‘call routing’ menu see page 34.