Operator`s manual

16
Contact Details
The SD2 can store up to 10 contacts; each contact is assigned the
following parameters:
Name
Up to 16 characters can be assigned to the contact name.
Telephone No.
Each contact’s telephone number can have up to 24 digits. When
programming the contact’s telephone number the  key can be used to
insert the following command characters:
* Star: Inserts a * into the telephone number.
# Hash: Inserts a # in the telephone number.
, Pause: If the unit is connected to an internal telephone system you
normally have to dial a number to get an external line, wait a couple of
seconds, then dial the actual number. The pause command can be used to
insert a 3 second delay, e.g., (9,) 0161 123456.
Contact Type
The contact type can be programmed to one of the following options:
Voice Only:
The SD2 dials the contact telephone number and plays the common phrase
plus the relevant voice message, repeated four times.
Text Only:
The SD2 dials the SMS service centre and relays the relevant text message
to the Contact’s telephone number.