User's Manual

7
ENGLISH
What to do if . . .QUENTIAL DAMAGES RESULTING FROM
Is there power to the floodlight?
•
Check to see that the circuit breaker has not
been tripped.
• Be sure the wall switch is in the “ON” position.
•
Be sure that the bulb is not burned out or broken.
Is the surrounding external ambient light too bright? (If so,
the unit may think it’
s daytime.)
•
Relocate or reposition the unit away from the light.
Do the batteries need replacing in landscape motion sensor?
TURN OFF POWER BEFORE CONTINUING.
Is the wiring to the fixture loose?
•
Check wiring and reconnect, if necessary, using Quick-
Connect
TM
or wire nuts provided.
OUTDOOR
FLOODLIGHT
DOES NOT COME
ON WITH MOTION
AT NIGHT
Is there motion in the detection zone?
• Make sure the sensor is not picking up moving objects
such as trees, traffic, etc.
TEST FOR YOURSELF
• Cover the sensor lens with cardboard to prevent sensor
from detecting motion. If the floodlight stays off, some-
thing in the detection zone is triggering the sensor.
• If this is the case, reduce the sensitivity.
* If the light stays on with sensor lens covered, contact
customer service.
Is the unit in the AUTO mode?
OUTDOOR FLOODLIGHT
COMES ON FOR NO
APPARENT REASON
AT NIGHT
FLOODLIGHT CONTINU-
OUSLY BLINKS ON AND
OFF AT NIGHT
The light given off from a lantern or a light source next to it is
affecting the motion sensor.
• Reposition away from light.
CANNOT ACTIVATE
DUSK T
O DA
WN MODE
AT NIGHT (OVERRIDE)
Is the surrounding external ambient light too bright? (If so, the
unit may think it’s daytime.)
• Relocate or reposition the unit away from the light.
Are you allowing adequate time to enter the dusk to dawn
mode?
•
T
urn the inside light switch to the “OFF” position for 5
seconds, and then back to the “ON” position.
FLOODLIGHT STAYS ON
AT NIGHT AND DOES
NOT TURN OFF
Is there motion in the detection zone?
• Make sure the sensor is not picking up moving objects
such as trees, traffic, etc.
• If this is the case, reduce the sensitivity.
• Rotate lens to reposition motion sensor.
If there is no motion, then the unit may be in the override
mode.
• Turn the inside light switch to the “OFF” position for 90
seconds, and then back to the “ON” position. This will
send the unit back into the AUTO mode.
* If the floodlight continues to stay on, contact
customer service.
Is the unit in the AUTO mode?
FLOODLIGHT IS ON
DURING THE DAY
Is the switch on the floodlight base plate in the test mode?
• Move the switch to the AUTO 4 or AUTO 12 position.
Is the motion detector shadowed?
• Reposition motion sensor.
• Reposition floodlight.