User's Manual

3
Install a wall switch adjacent to the power source.
(FIGURE 9). This will help you operate this PIR
LIGHTING CAMERA with ease. See OPERATION for
further information.
European Version
American Version
FIGURE 9
WIRING INSTRUCTION
European Version
(1) Switch off the power source or wall switch
(2) Detach the wiring box from the backplate.
(3) Use a flat blade screwdriver to break a hole on the
rubber gasket. Route the power cord through the
rubber gasket and strain relief by fastening the
power cord with two screws provided.(FIGURE
10)
R
FIGURE 10
4
(4) Using the backplate as a template to mark the
position of two fixing holes on the wall. Drill these
two holes by inserting the plastic wall plugs
supplied. Fix the backplate using the two screws
provided. (FIGURE 11)
FIGURE 11
(4) Connect the BROWN wire (Live wire) to the
terminal block “L” mark.
Connect the BLUE wire (Neutral wire) to the
terminal block “N” mark.
Connect the YELLOW/GREEN (Ground wire) to
the terminal block “
“mark. (FIGURE 12).
FIGURE 12
(5) Place the wiring box to the backplate using
screws provided. (FIGURE 13)