User's Manual

1
z The adjustable angle for the floodlight and PIR
Camera can be 45° leftward and rightward.
(FIGURE 4)
FIGURE 4
z The suggested swiveling angle of floodlight and
PIR Camera are outlined hereunder: (FIGURE 5)
Wall mount Ceiling mount
FIGURE 5
IMPORTANT
Installation must be performed by skilled technicians
who are informed about the standards and technical
requirements of the appliance and its proper
installation.
Maintenance or repairing work such as replacing
current fuse shall be done by a qualified electrician
or technician.
Before proceeding with the installation, TURN OFF
THE POWER TO THE LIGHTING CIRCUIT AT THE
CIRCUIT BREAKER OR FUSE BOX TO AVOID
ELECTRICAL SHOCK.
CHOOSING A MOUNTING LOCATION
z For the best results, fix your PIR LIGHTING
CAMERA on a solid surface, 2M above the
ground.
z For outdoor installation, a location under eaves is
preferable.
z Avoid aiming the motion sensor at pools, heating
vents, air conditioners or objects that may
change temperature rapidly.
z Do not allow sunlight to fall directly on the front of
unit.
z Try to avoid pointing the unit at trees or shrubs or
where the motion of pets may be detected.
z The transmission range to the Wireless Receiver
is up to 100m in clear line of sight.
z Prior to mounting, keep in mind that the motion
sensor is more sensitive to the motion, which is
across the detection field and less sensitive to
the motion, which moves directly towards the
detector (FIGURE 6).
2
SENSOR SENSOR
LESS SENSITIVE MORE SENSITIVE
SENSITIVITY TO MOTION
FIGURE 6
BULB INSTALLATION
CAUTION: Always handle halogen bulbs with a soft
cloth. Do not touch the bulb with your bare
hand as it will shorten the life of the bulb.
(1) Do not touch the floodlight while it is in use or still
hot. Allow it to cool off (about 5 minutes) before
touching it.
(2) Do not use halogen bulb rated higher than 150
watts.
(3) Disconnect the power cord or wall switch.
(4) Unscrew the screw at the bottom of floodlight
(FIGURE 7).
FIGURE 7
(5) Install bulb by inserting one end first and
depressing until enough clearance is gained to
seat the other end of the socket. Rotate halogen
bulb to assure proper seating.
(6) Carefully replace the front surround and make
sure that the seal is correctly positioned and then
screw up tightly.
INSTALLATION
To facilitate installation, it is essential to get a drill and
a screwdriver ready. Select a location for the unit
based on the coverage angles shown in FIGURE 8.
FIGURE 8
90¢X
90¢X