Specifications

6" Incandescent
DIMENSIONS
DESCRIPTION
The ET2700 housing is designed
for use in shallow ceilings. For
use in non-insulated ceilings. If
ceiling insulation is present, it
must be kept 3 inches from all
sides of housing.
Housing
• Die-stamped CRS with white
powder coat finish
Socket Plate
• Rigid socket plate adjusts and
locks without tools for various
lamp sizes
Plaster Frame
• Galvanized steel construction.
• Housing adjusts in plaster
frame 1-3/8" to accommodate
different ceiling thicknesses
• Regressed locking screw for
securing hanger bars
• Cutouts for easily crimping
hanger bars in position
Junction Box
• Positioned to accommodate
straight conduit runs.
• Seven conduit knockouts are
uniform 1/2" size with true
pryout slots.
• Four pryouts with integral
strain relief simplify “NM”
non-metallic sheathed cable
installation.
• Three quick connect wire
connectors included.
ALL-NAIL™ Bar Hangers
Bar Hanger features include:
• Pre-installed nail.
• Mini leveling foot aligns the
housing to the bottom of the
joist.
• Housing can be positioned at
any point within 24” joist spans
• Score lines allow tool-free
shortening for narrow joist
spacing.
• Bar hangers may be
repositioned 90° on plaster
frame
• Integral T-bar clip snaps onto
T-bars – no additional clips are
required
Socket
Porcelain E26 socket with nickel
plated brass screw shell, snaps
into trim for consistent lamp
positioning.
Thermal Protector
Integral Thermal Protector
deactivates fixture if an incorrect
lamp is used or if ceiling
insulation material is not
applied correctly.
Labels
• UL/cUL Listed 1598 Luminaire
• UL/cUL Listed for Damp Location
• UL/cUL Listed for Feed Through
• UL/cUL Listed for Wet Location,
covered ceiling
• IP Rated (Improper Lamp)
6-1/2"
[140mm]
5"
[127mm]
1/2"
[13mm]
10-1/2"
[267mm]
7-1/2"
[191mm]
112
Note: Some units may have
different features.
Visit www.cooperlighting.com for more information on the complete ALL-PRO Stock and
Specification offering. Product availability subject to change without notice.
ET2700
6˝ Aperture, Non-IC,
Shallow Ceiling,
New Construction,
120V Line Voltage
Specifications
• Non-IC housing
• May be used in insulated
ceilings but insulation
MUST be kept 3" from all
sides of fixture
• For use with 120V
incandescent lamps