Specifications

Dimmer Notes:
1. Start time is measured at the lowest dimmer setting.
2. Some LED rated dimmers have a "rapid start" design used to provide a momentary power boost for LED and CFL
lamps during start-up. When a LED luminaire is on a dimmer with "rapid start" the boost may cause a momentary
flash of the LED lighting. This "flash" is generated by the dimmer, and may be more noticeable when the dimmer
is at a low setting. A solution is available in the following EATON dimmers which provide adjustment capability of
the "rapid start": Decorator (DAL06P), Smart (AAL06), and Toggle (TAL06P). Refer to product specifications online at
www.cooperwiringdevices.com for more details.
Dimming Guide Disclaimer:
1. Leviton
®
is a registered trademark of Leviton Manufacturing Co. Inc.; Lutron
®
is a registered trademark of Lutron
Electronics Co. Inc.; Lightolier
®
is a registered trademark of Philips Lighting; Hubbell
®
is a registered trademark of
Hubbell Incorporated; Legrand
®
and Pass & Seymour
®
are registered trademarks of Legrand
®
. These companies and
their tradenames, trademarks or brands, where noted, are associated with their respective company and are not
associated with EATON.
2. Testing conducted by EATON is not a substitute for and does not imply certification by an independent laboratory or
any other standards certification. Refer to the manufacturer specifications for more detailed information on product
certifications and standards.
3. This is a representative list of typical dimmers as tested by EATON for performance with the designated LED
luminaires only. Test data contained in this literature is based upon dimmers obtained in the marketplace. 
• Information about these other manufacturers products is obtained from packaging and published information
made available by the manufacturer and is deemed to be reliable, but has not been verified. 
• Dimmer performance and perceived limitations of the dimmers are based onfactors outside of EATON's control.
• The specifications of these dimming controls and their conditions of use may change without notice to EATON or
any other user. 
• EATON makes no specific recommendation on product selection and there are no warranties of performance or
compatibility implied. 
• Installer must ensure proper local and national electrical codes are followed; and that the dimmer application and
condition of use is per dimmer manufacturer instructions and guidelines.
4
HALO SMD Dimming Guide - PA518058EN