Technical Specifications

Specifications and dimensions subject to change without notice.
Sure-Lites • Customer First Center • 1121 Highway 74 South • Peachtree City, GA 30269 • TEL [phone] • FAX [phone]
AP EL SERIES
TE C H NI C A L DATA
LED H e a d s
The Long Life LED Emergency Heads are the
most economical Emergency Light solution for
general purpose applications. Designed
specifically for emergency lighting applications
with horizontal and vertical adjustment by
rotating the LED Emergency Heads to desired
direction.
Hous i n g C o n s t ru c tion
Rugged, durable, injection molded
thermoplastic materials are used throughout the
All Pro Series Emergency Lighting Units. All
structural components are designed with
reinforcing ribs to add additional rigidity and to
maximize structural integrity. These materials
are impact and scratch resistant, and they have
been UV stabilized to resist discoloration due to
age and ultraviolet radiation. All components
are designed to be of snap-fit construction - no
mechanical fasteners - to facilitate installation in
under 5-minutes. The mounting plate has
keyhole mounting slots and a universal
mounting pattern for quick, efficient installation.
Any components required for installation
(wirenuts, wire leads, etc.) are all included with
each unit. All APEL Series Units are suitable for
wall or ceiling mount applications.
Line - L a t ched
All Pro Emergency’s line-latched electronic
circuitry makes installation easy and
economical. A labor efficient AC-activated load
switch prevents the lamps from turning on
during installation to a non-energized AC circuit.
Linelatching eliminates the need for a
contractor’s return to a job site to connect the
batteries when the building’s main power is
permanently turned on.
Soli d - S t a te C h a rge r
Supplied with a 120/277 VAC, voltage regulated
solid-state charger. Immediately upon
restoration of AC current after a power failure,
the charger provides a high charge rate. The
charge circuit reacts to the condition of the
battery and alters the rate of charge in order to
maintain peak battery capacity and maximize
battery life. Solid-state construction recharges
the battery following a power failure in
accordance with UL 924.
Brow n o u t C i rc u i t
The brownout circuit in All Pro Emergency units
monitor the flow of AC current to the unit and
activates the emergency lighting system when a
predetermined reduction of AC power occurs.
This dip in voltage will cause most ballasted
fixtures to extinguish causing loss of normal
lighting even though a total power failure has
not occurred.
Low Vo l t a ge D i s c o n n ect
When the battery’s terminal voltage falls below
80% of the rated voltage, the low voltage
circuitry disconnects the lighting load. The
disconnect remains in effect until normal utility
power is restored, preventing deep battery
discharge.
Te s t Sw i t ch / Po we r I n d i c ato r L i g h t
A test switch permits the activation of the
emergency circuit for a complete operational
system check. The Power Indicator Light
provides assurance that the AC power is on.
Seal e d N i ckel Ca d m i u m B a tt ery
All Pro Emergency sealed nickel cadmium
batteries are maintenance free with a life
expactancy of 15 years. The sealed rechargable
nickel cadmium battery offers high discharge
rates and stable performance overa a wide
range of temperatures. The specially designed
resealable vent automatically controls cell
pressure, assuring safety and reliability. This
battery is best suited for harsh ambient
temperatures because the electrolyte is not
active in the electrochemical process.
Warrant y
All Pro Emergency units are backed by a five-
year warranty.
ADX110026 pc
2011-10-19 09:21:03