Installation Instructions

User Manual: WaveLinx Lite (1.5)
50
www.cooperlighting.com
6: In the list of devices in the zone, locate the device and if needed, use the identify icon ‘ ‘ to flash the devices until the correct one is found,
Tap on the device to open the ‘Device Details’.
7: The ‘Dimmable’ device detail page should appear. Locate the ‘Daylight Set’ and note the name of the set.
8: (Recommended/Optional) To make it easier to find or adjust in the mobile app, the daylight set can be renamed. Tap on the ‘>’ icon to open
the daylight set, and then tap on the pencil icon ‘ ’at the top of the settings screen, entering a unique, descriptive name.
Disable and Enable Daylighting for a Specific Sensor
• Daylight dimming and dim-to-off functionality is enabled by default for outdoor closed loop sensors. If the devices are located in areas that
should not respond to daylighting disable the daylight set.
• Daylight dimming and dim-to-off functionality is disabled by default for interior closed loop sensors and will need to be enabled for lighting to
respond to daylighting.
Before proceeding with the below instructions, identify the daylight set using the instructions starting on page 49.
To disable or enable daylighting for a sensor:
1: Bring the mobile device within range (within 60 feet) of any provisioned WaveLinx Lite device in the desired area.
2: Ensure that the mobile device Bluetooth is turned on, and then open the WaveLinx Lite Mobile Application.
3: In the site list, select a site.
‘Dimmable’
device details
Identified
daylight set
If needed, use ‘identify’ to
locate the correct device
Tap device to open the
‘Device Details’
Tap ‘>’
Tap the pencil icon
to rename
WARNING: Disabling the daylight set will cause fixture mount and integrated sensors to operate solely from motion
sensor activity. The occupancy sensor will trigger response during daytime and nighttime hours regardless of light
level. If response is desired ONLY when there is not adequate daylight, the daylight set must be enabled.